Kia Blind Spot Detection Not Working

When i shut the car off it went off.

Kia blind spot detection not working.

If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized kia dealer and have the system checked. Again the company chose not to discuss vehicle speed control systems through the manufacturer communications. If there is no problem mount the bumper back and perform bsd. If a failure code is displayed or a warning lamp turns on even after performing bsd radar correction 5 times replace the bsd unit.

If you found any problem in the bsd unit bracket or nut tightening correct the problem or replace the component. If the system does not work properly a warning message will appear and the light on the switch will turn off. Be careful when removing the blind spot detection unit. Of course the blind spot alarm does not alarm if you don t signal for a lane change.

If the system does not work properly a warning message will appear and the light on the switch will turn off. I m in northern california and was in fog mist by the coast at a standstill on the freeway due to an accident. I was driving to work and the warning light came on blind spot radar detector blocked. Service bulletin tsbele154 states that the blind spot collision warning malfunctions with a dtc c270254.

Remove the bsd assembly a after loosening the mounting nuts. Once i got moving the light remained on until i got to work. The bracket may break off from the bumper. Disconnect the bsd connector a from the bsd unit.

Remove the foreign matter on the rear bumper. If the system does not work normally even though the foreign matter is removed take your vehicle to an authorized k900 kia dealer and have the system checked. And blind spot alarm is sure nice when backing out of parking spot if you are careless and not checking mirrors backup camera or looking. When removing the bsd unit be careful not to damage the bracket of bsd.

Remove the foreign matter on the rear bumper.