Some of the more common kenmore refrigerator issues include temperature control problems noisy ice makers or condenser fans that keep running even after the fridge has reached a designated temperature.
Kenmore refrigerator evaporator fan not working.
On this model the defrost thermostat can cause the fan not to come on as well.
If this occurs the freezer may still get cold while the refrigerator will not get.
That is the most common thing on this unit.
If the evap fan is not working the freezer will be cold near the evap unit but not elsewhere in the freezer.
If the evaporator fan is not working it will not circulate the cold air to the refrigerator compartment.
If the freezer isn t working you should be able to tell quickly.
Repair clinic exists to help you figure out what s wrong and to provide all your replacement parts from storage shelves to fan motors.
Let s check the wiring first.
Next plug the fridge in and wait for the compressor to come on.
The fan should also come on.
If the unit and fan is iced over this means that either the defrost heater is not working the defrost timer is not working the control board is faulty etc.
The defrost cycle varies between makers.
Open the freezer door and feel for cool air with your hand.
Kenmore refrigerator freezer not cold one of the most common reasons for the freezer to start failing is called frost free failure ice can build up on the evaporator coils over time and this ice builds up until it starts blocking the fan.
On refrigerators with only one evaporator the evaporator is located in the freezer compartment.
If your kenmore or whirlpool refrigerator has stopped cooling it could be due to a bad fan inside the freezer.
If the evaporator fan motor stops working your freezer will begin to defrost.
Unplug the refrigerator and remove the screw that holds the control box.
There are a number of other things that will.
Pull the fridge away from the wall unplug it and remove the thin panel on the back near the bottom to access the compressor and condenser fan.
Some refrigerators have more than one evaporator fan motor.
If the evaporator fan doesn t run in the diagnostic test mode then you could have a defective control board but the problem could also be a bad evaporator fan or a break in the wiring.