Kenmore In Door Ice Maker Troubleshooting

If the door switch does not have continuity when activated replace it.

Kenmore in door ice maker troubleshooting.

When the freezer door is opened the freezer door switch does two things it turns on the light in the freezer and turns off the ice maker and dispenser. In order for the kenmore elite ice maker to operate properly the water pressure coming from the faucet should be 120 psi at the very least. The kenmore website provides other ways to troubleshoot your. To determine if the door switch is defective use a.

Check the fill cup. The switch can be checked for continuity with an ohm meter. If your icemaker module does not work correctly it will not eject ice cubes. Troubleshooting kenmore ice maker not working a faulty inlet valve may cause significant problems by delivering insufficient water.

Multimeter to test it for continuity. Check the auger to determine if it is broken or if it is disconnected from the auger motor. Grip the handle at the bottom of the ice bin and pull it up and out of the ice compartment housing. Refer to the installation manual for additional help with this step if needed.

If the auger is broken replace it. If the refrigerator ice maker is not working the door switch might be defective. If the door switch fails the dispenser will not turn on. Open the ice maker compartment door to access the ice maker assembly.

Perhaps your ice maker is making ice but it s leaking water in the freezer or leaking onto the floor. Check your ice maker unit and make sure it s level. As the auger rotates it pushes the ice toward the dispenser door and down the chute. In this case you must gently dismantle.

Check the water lines in the back of the refrigerator to see if there is a visible kink or clog from the hard water that flows from the house line system. Remove the ice bin. If the door switch fails the dispenser will not turn on. I need to know how to fix an ice maker on a kenmore refrigerator.

Check the water supply line for damage pinching or kinks. If the auger is defective it won t be abl e to push the ice out of the dispenser. If the water pressure in your area is relatively low make sure that you use a thinner hose to connect the ice maker to the water supply. If someone turned it off i have a different pr.

Check your refrigerator and make sure it s perfectly level. The door switch turns off the ice and water dispenser when the refrigerator door is open. Please verify whether your house s. Flush the lines with a solution of one part vinegar and one part water.

I m assuming someone actually turned it on.